Two-post hydraulic press for stamping, sheet metal deformation and assembly. The PST press is made with a monolithic frame, assembled and TIG welded with internal reinforcements.

The mobile upper plane features 2 self-lubricating guides as standard for models up to 200 tons and 4 guides for 300 and 400 ton models. It is also equipped with T-slots for fixing the molds. The lower table is instead bolted to the frame and is also equipped with T-slots. The hydraulic control unit has 2 operating speeds, one for approach under 30 mm/sec and another for work which is activated when the upper table comes into contact with the piece to be worked on.

The PST electro-hydraulic press is supplied in models starting from 40 tons up to 400 tons and is available both in the semi-automatic version and with automatic operation.

Semi-automatic version This system works with the simultaneous use of the lever and the ignition button and is equipped with rod end stroke sensors, which regulate the ascent and descent of the cylinder.

Automatic version The PST electro-hydraulic press in automatic mode can be operated by simultaneously pressing the dual buttons and is also equipped with microswitches for adjusting the cylinder stroke. The work table automatically raises at the end of each pressing cycle. This version also includes the installation of the Siemens PLC and Rexroth solenoid valves. The PST workshop press machine also features a pedestal-mounted console with all major controls.

Accessories: 4 lateral self-lubricating sliding guides for models up to 200 tons. Blank holder cushion from 20 to 80 tons.

Accessories (only for automatic version): Front light barriers – Digital control with Siemens display – Digital control of the blank holder cushion Timer Piece counter Air/oil heat exchanger with decompression valve Decompression Pressure switch