On request, the Siemens KTP 700 Basic touchscreen display can be installed, which allows the following parameters to be set:

    • Corsa massima del cilindro idraulico in salita e in discesa
    • Pressure maintenance time on the lower platform
    • Work pressure
    • Decompression time
    • Piece counter
    • Ascent/descent pre-stop: This function allows you to stop the ascent or descent before reaching the desired height, thus eliminating errors caused by speed and cavitation due to the mold's weight. It guarantees an accuracy of 0.1 mm.
    • Alarm management

It is possible to store up to 100 different machining programs.

Allows you to choose whether to work in manual or automatic mode.

The stroke reading is done via a wire encoder, while the pressure reading is done via a transducer installed on the hydraulic power unit.

If a hydraulic cushion is installed, it is possible to install as an additional accessory the possibility of managing the operation of the hydraulic cushion via the digital screen.